There are many technological advancements that have come out in recent years for HVAC systems. If you are going to install one at your facility, or perhaps at your home, you want to use the ones that will provide you with the most advanced and cost-effective products. If you are installing an air conditioning system, or if it is a heating system, you need to know that it will help keep temperatures in your house or building at a constant level. In addition to this, there should be a cost savings associated with not only the installation but operating the device. Here is a brief overview of how you can benefit from the latest technology in HVAC systems.
What Advancements Have Been Made?
If you do have an HVAC system that your house, it probably consists of a heater and air conditioning unit. These are going to blow hot or cold air through your ducting system. Depending upon their size, and the amount of ducting that you have, they can be very expensive to use. Some of them are going to operate on electricity, whereas others will use propane or oil. However, there have been advancements in technology that allow you to save money on the cost of using them. That is because of technological advancements in solar energy and in geothermal energy sources.
Movement Activated Air Conditioning
One of the best advancements in this technology is in the form of movement activated air conditioning units. For example, if you are not in the room, but you have left it on, it will shut itself off of it does not detect any movement over the course of a couple of minutes. This is something that can save you a lot of money, even if you have a thermostat which is theoretically going to turn off once the temperature reaches a particular level. This added technological advancement will help you save even more money, regardless of how it is powered.
On-Demand Hot Water Recirculation Systems
Another possibility is to use a hot water recirculation system, one that is able to take cold water that would otherwise be wasted and putting it back into the hot water tank. This can be beneficial if you have a couple different hot water systems, one of which is providing the sheet for your entire home. For example, there are some systems that use hot water tanks. These can be powered by solar power, propane, oil, electricity, or a number of other sources of energy. Even if you are using geothermal energy, when you are able to recirculate the water back into the hot water tank, this is going to save you money.
Thermally Driven Air Conditioning
This would be better identified as something called a hybrid air conditioning unit. That’s because it uses a combination of propane and solar energy. For example, if you have a very hot summer, and you have a very good southern exposure to absorb as much sunlight as possible, your solar panels will power the air conditioning units without any problems during the day. However, during the night, if you have not stored enough of the battery power, you can use natural gas, oil, or even kerosene in order to keep it running all night long. By balancing out your energy usage, you will end up paying very little just to keep your house as cool as possible.
Dual Fuel Heat Pumps
This is another hybrid system which is designed for maximum efficiency. It’s going to use a combination of electricity and a gas furnace. In the same way that the prior example mentioned how an air conditioning unit can use to sources of energy the house cool, the same can be done with a heater. This may even be connected with geothermal heat pumps which are very energy efficient. Depending upon how deep those are in the ground, they can literally cost you no money at all. Of course, there is the cost of installing these which can be quite expensive depending upon the hardness of the ground, and how deep you have to go, but it still going to pay for itself in just a few short years using this technology.
Fully Automated Homes
Perhaps the greatest advancements in the last five years has been the advent of fully automated homes. We have seen these portrayed in science fiction movies for decades. However, due to the power of computers, and the technology that has been developed, the software that these systems uses is able to monitor everything in your house. Not only can you turn on the lights by asking it to do so, it will also monitor the temperature in every single room. These typically have a sensor in every room which can detect air temperature. Therefore, it will only send hot or cold air into the rooms that needed the most. This will also help you save a lot of money when you are with a family with small children that are constantly turning on lights. Everything is monitored, and as a result of that, you can save what could be hundreds of dollars on your utility bills by using one of these systems.
There are other forms of technology that have really helped improve the way that people are able to cut back on their utility bills by using these advanced systems. From geothermal heat pumps to ice powered air conditioners, you really can’t go wrong by installing at least one of these systems. For those that are old-fashioned and would prefer not having a computer monitoring everything in their home, that might not be the direction that you will want to go. At the very least, take advantage of the sensors for each room, and the dual forms of energy that can be used in order to maintain constant temperatures within your house or office. Finally, get estimates from the different contractors that will install these, visit the bluon energy review post. This will ensure that you are getting the best possible price when you have is energy saving cost effective systems installed.